Miata Harmonic Balancer Removal. just use an impact gun and the bolt will come out and the balancer will pull right off. i need to remove the crank nose bolt for the harmonic balancer due to an oil leak apparently coming from the front main seal. hi everyone, i'm hoping for some advice on replacing the harmonic balancer in my 99. Any tips on the removal? i have never had to use a puller to get a harmonic balancer off, it usually just slides right off. If you don't have access to air. i was just curious on of i could still remove the whole harmonic balancer with the face plate screws still on since that one 10mm bolt is. I ordered a new one from rock auto. Also works great for torquing the harmonic balancer back to spec after the job is done. so i took off the 4 10mm bolts but the balancer is still stuck on. it has been about a week since i worked on it last, i removed the 4 small bolts that hold on the harmonic balancer and. this trick is mainly for if the transmission is off. The tough part is getting the crank nut off. No need for pullers just make sure not to lose the snout key.
from trackdogracing.com
Any tips on the removal? If you don't have access to air. i have never had to use a puller to get a harmonic balancer off, it usually just slides right off. i was just curious on of i could still remove the whole harmonic balancer with the face plate screws still on since that one 10mm bolt is. i need to remove the crank nose bolt for the harmonic balancer due to an oil leak apparently coming from the front main seal. The tough part is getting the crank nut off. just use an impact gun and the bolt will come out and the balancer will pull right off. Also works great for torquing the harmonic balancer back to spec after the job is done. it has been about a week since i worked on it last, i removed the 4 small bolts that hold on the harmonic balancer and. I ordered a new one from rock auto.
Fluidampr Harmonic Balancer for 20062015MX5 Miata
Miata Harmonic Balancer Removal Also works great for torquing the harmonic balancer back to spec after the job is done. i need to remove the crank nose bolt for the harmonic balancer due to an oil leak apparently coming from the front main seal. Any tips on the removal? If you don't have access to air. Also works great for torquing the harmonic balancer back to spec after the job is done. this trick is mainly for if the transmission is off. so i took off the 4 10mm bolts but the balancer is still stuck on. i was just curious on of i could still remove the whole harmonic balancer with the face plate screws still on since that one 10mm bolt is. i have never had to use a puller to get a harmonic balancer off, it usually just slides right off. hi everyone, i'm hoping for some advice on replacing the harmonic balancer in my 99. No need for pullers just make sure not to lose the snout key. it has been about a week since i worked on it last, i removed the 4 small bolts that hold on the harmonic balancer and. just use an impact gun and the bolt will come out and the balancer will pull right off. I ordered a new one from rock auto. The tough part is getting the crank nut off.
